While installing a LED illuminator board in my G-1000SDX controller, one
wire on the indicator motor controller board separated from the other
end. This is the first one of the pair of gray wires attached to the
motor controller board at the top right corner (viewed from the rear of
the controller unit and marked "10" on the circuit board). It crosses
the back of the motor control board then wrap toward the face plate;
this is the loose end.
Can someone who owns one of these units could open the controller and
tell me where this wire should connect? I have neither an owners manual
or a schematic diagram. A copy of either would also be appreciated.
Note this is the SDX unit, which is considerably different than the DXA
unit.
Thanks es 73,
Dave KE4S
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|