Towertalk
[Top] [All Lists]

Re: [TowerTalk] Barker & Williamson Model AC - 1.8 - 30 Antenna

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Barker & Williamson Model AC - 1.8 - 30 Antenna
From: Jim Brown <jim@audiosystemsgroup.com>
Reply-to: jim@audiosystemsgroup.com
Date: Mon, 4 Jan 2016 17:32:29 -0800
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
On Mon,1/4/2016 5:09 PM, Alan Swinger wrote:
I have one of these and used it a few yrs back with the ground wire. Found it to be very 
marginal and not even a good dummy load. BTW, do not exceed the 1 KW PEP limit or that 
"Coupling" unit (just a big resistor) will burn up. Any decent dipole or windom is 
much better than this B&W piece of junk!

I just looked at this "antenna" on the Universal Radio website. It's a lousy excuse for an antenna -- in addition to the loss in that big resistor, the connection between those two ground rods is also a big resistor. And because it's low, there's even more loss, and most of what little it does radiate goes straight up.

To the original poster -- toss this piece of crap in the trash, buy a copy of the ARRL Antenna Book, some #14 wire at the big box store, a center insulator and end insulators from the Wireman, and make yourself a REAL antenna.

73, Jim K9YC
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>