How’s this for a solution... specifically for the antenna I have ... the M2
40M4LLDD which has linear loading wires that loop back towards and come close
to the vertical uprights that support them... what if I installed a vacuum
relay with one side connected to the center of the LL end ... and the other
side to the upright thus when activated it would short the LL! This would most
definitely destroy any resonances on 15. I could have the relays all connected
together such that when 15 is the active band it automatically closes the
relays... by using ferrites on the power lead to the relay it would isolate any
other effects of the arrangement. Granted it is 8 relays ... but I believe it
would be quite effective... thoughts anyone?
I found a picture on how Optibeam does it and indeed I was right – they just
use a parallel line to the element with a cap in series with this line to
create a parallel tuned trap. But they have coils – and thus can do this
readily ... the LLDD doesn’t and I don’t know that I could implement this
outside the LL wires... but I’ll see... I understood, possibly incorrectly,
that NEC2 can’t handle close wires – if it is spaced say 3” would that model ok?
If I were to try this on the LL it would of course have to be on the far side
of the LL... I’d suspect placement isn’t an issue since wherever it is placed
it will destroy resonance on 15 ... with the flip side being not to introduce
resonance, at least for me, on 20 since I have 20’s nearby the 40...
or... I could maybe just do a trap from the center close point of the LL wires
back to the upright ... just not sure if that would be high enough impedance
(when using it on 40) not to destroy performance on 40.
or... a series trap shorting the LL lines ... again just not sure if it would
be high enough impedance to not effect 40...
I suspect both of these latter two wouldn’t be high enough impedance and it
would noticeably effect 40.
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
ok – sorry – stub.
Specifically adding something to a 4 element 40 to eliminate 15 meter
interaction? I believe Optibeam does this – not sure how they do it. Is this
just using the element with a parallel line tuned through a cap for max current
on 15? If so any suggestions on how long to make it and where specifically to
put it on each element 1/2?
Or is there a way to use a relay, open normally, closed when on 15 that would
add some impedance to the antenna causing it to be detuned at 15? Alternatively
I can rotate the antenna 90 degrees but boy it would be so much better not to
have to do that to avoid interaction on 15.
thanks in advance,Gary K9RX
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|