Towertalk
[Top] [All Lists]

Re: [TowerTalk] Force 12 feedpoint matching coil redux

To: "'Howard Hoyt'" <hhoyt@mebtel.net>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] Force 12 feedpoint matching coil redux
From: "John Santillo" <u1004467@warwick.net>
Date: Sun, 27 Dec 2015 11:37:39 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Howie,

Yes, I own a C4SXL and it is needed to provide the proper match.  

My coil is 3 Turns with an inside diameter of 2.75" and the coil is made of
solid 8 Gauge copper wire.  When my old coil fractured I used .125" copper
tubing and that worked just fine. 


73,

John
N2HMM


-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of
Howard Hoyt
Sent: Sunday, December 27, 2015 10:58 AM
To: towertalk@contesting.com
Subject: [TowerTalk] Force 12 feedpoint matching coil redux

Hi TowerTalk braintrust,

Can owners of the Force12 EF240S / C4SXL tell me if the 3T loading coil is
needed on the 40M driver feedpoint for a proper match?  In the manual it
calls out one, but the used antenna I got had that coil cut off.  I
contacted Force12 and asked them for the specs of the coil so I could make
one but they said they would have to research it and I've not heard back.

I considered trying to model it in EZNEC, but I can't physically measure the
linear loading section because  mine is taken apart. Does anyone have an
EZNEC model of the C-4SXL/EF240S... to share?

Cheers & 73,

Howie - WA4PSC




_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>