Or add a few wraps of silicone tape on the smaller diameter before heat
shrinking over it.
-Steve K8LX
On 12/19/2015 11:17 PM, n8de@thepoint.net wrote:
Fill it with RTV silicone seal before you shrink it.
Quoting Tony <dxdx@optonline.net>:
Is there shrink tubing that will reliably shrink by a 4:1 ratio? I
tried using some tubing I had on hand to cover several N-connector
jumpers with LMR-240 cable. It worked fine on the connector, but would
not shrink around the 1/4 inch cable.
Any suggestions?
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|