Tony,
I use the RFU507SI for Davis Buryflex, LM400 and 9913. I use the
RFU507ST for RG213/RG-8U and the RFU507STF for RG-214. They are all
different in pin diameter and jacket size.
73 Bill N4LG
At 12:19 AM 11/6/2015, Tony wrote:
All:
Davis RF Buryflex cable is a great product, but I'm finding it
difficult to get the center conductor inside the connector pin
without fraying the stranded wire. I'm using a coax prep tool and
keeping the center conductor from becoming deformed, but it seems
the connector that Davis RF recommends (RFU-507-SI) needs more
chamfering on the pin to help prevent this problem.
I was thinking about tinning the tip of center conductor and then
grinding it to a point with Dremel tool or maybe using a drill bit
to add more chamfer to the pin.
Maybe there's a connector out there that's easier to install? Any
suggestions?
Thanks,
73, Tony
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|