For lateral loads
-----Mensaje original-----
De: TowerTalk [mailto:towertalk-bounces@contesting.com] En nombre de Roger
(K8RI) on TT
Enviado el: domingo, 01 de noviembre de 2015 12:29 p.m.
Para: towertalk@contesting.com
Asunto: Re: [TowerTalk] clamp on trhust bearing
Thrust bearing to support lateral loads, or to take load off the rotator for
changes? Split blocks work great for lateral loads. Oil soaked hard wood, or
high density PE.
73
Roger (K8RI)
On 11/1/2015 6:20 AM, Jorge Diez - CX6VM wrote:
> Hello
>
>
>
> I have a yaesu 065 thrust bearing broken up in the tower, after a
> rotor replacement. Inside a mast with two antennas
>
>
>
> I don t want to remove all antennas and mast to replace the thrust
> bearing from 200 ft tower, so wondering if there s a CLAMP ON thrust
> bearing or crapodine I can get to replace it without need to remove
> all antennas and mast
>
>
>
> Thanks,
>
> Jorge
>
> CX6VM/CW5W
>
>
>
> ---
> El software de antivirus Avast ha analizado este correo electr nico en busca
> de virus.
> https://www.avast.com/antivirus
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
--
73
Roger (K8RI)
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
---
El software de antivirus Avast ha analizado este correo electrónico en busca de
virus.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|