There are a lot of possible spots where the mixing can happen.
This brings up the question: Mixing with what? Nearby AM stations, ham
bands, and why every 10 KHz? What is the primary station, or stations
and their frequencies?
"Any section" making poor contact with those above or below, making
contact with coax braid, tension causing poor contact in connectors.
It's pretty certain it's related to cranking the tower up, but is it due
to poor contact in that position, or that it picks up more signal?
I assume the mixing is gone during the raising and lowering process. If
not, does it just get weaker as the tower is lowered?
I'd be surprised that it's not strong near the full extension while moving.
Places to start:: If the mixing is only present at full extension,
check for tension on the coax at the antennas, rotator loops, and at the
cable stand offs. Check the cable jackets, particularly where they pass
through the stand offs. Check cable jackets where they can move against
each other.
Use a VNA to check all coax at full and partial extension. Don't ignore
rotator cables and connectors either
If you don't have one, beg, borrow, or purchase one. With the tower
fully extended on a windy day, watch the traces for changes. Have you
tried a spectrum analyzer? Even the ones in the newer rigs can be
helpful, but you need to look between the bands as well.
Check the places on the tower sections where the skids/pads contact
adjacent sections for excessive wear and or missing galvanizing,
When the local repeater was here, I could block a 50W mobile a mile or
two distant simply by rubbing a 10" screwdriver against any of the
galvanized guy wires which were broken up with insulators. I had a TB3
tribander just below the repeater antenna @ 90 feet. Legal limit on 10,
15, or 20 did not bother the repeater.
73
Roger (K8RI)
On 10/19/2015 10:03 PM, Rich Hallman - N7TR wrote:
Has anyone had any problems with intermittent mixing from a close broadcast
station with a Crank-Up tower? I think I may have an issue with one of my
towers. Cranked up I hear mixing all over 80 meters (Every 10 KC).....Cranked
down its gone. I already eliminated the antennas. Mixing gets very
intermittent in wind as the tower moves around.
Thoughts about grounding the top section to the bottom when fully extended?
Was thinking of grounding the coax at the top and bottom of the tower?
Thanks....
Rich N7TR
ex KI3V, N3AMK, WB3JOV
www.n7tr.com<http://www.n7tr.com>
http://www.qrz.com/db/N7TR
Telnet: dxc.n7tr.com N7TR DXCluster
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
73
Roger (K8RI)
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|