Thanks Russ and Mike,
I don't like to put all my eggs in the MFJ basket but have to say the rig
here (FT1000D) and RF applications wattmeter basically confirmed what the
259b said. I think the next step is to rotate the boom 90 degrees and see if
that makes any difference. After that I may drop the TH-11 since it is
easier to get to and see again if the results change..I am only using 1
feedline and have checked it forwards and backwards. Will report back when I
get this figured out
73,
Steve, WD8NPL
-----Original Message-----
From: Russ Dearmore via TowerTalk
Sent: Friday, October 09, 2015 11:29 AM
To: towertalk@contesting.com
Subject: [TowerTalk] Cushcraft XM-240 problem
Steve, I was having similar problems in which logic was no help and it
turned out that my MFJ antenna analyzer was bad. Since then my bread and
butter analyzer is the iPortable iP60z. I now have 2 analyzers and it has
saved me a lot of time for sure.
Also once when I was really stumped it turned out that I had fried my coax
switching relay. After that I use single coax runs exclusively. Both
problems produced weird resonance dips. These problems shouldn't have been
that hard to figure out but I made it a real circus by trusting bad
equipment. Hopefully you have been able to verify your test equipment and
they are good. Sorry if my reply is too simplistic.... Russ K5ZZR My
Heroes Wear Combat Boots!
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|