| To: | Towertalk Reflector <towertalk@contesting.com> |
|---|---|
| Subject: | [TowerTalk] Ideal tool for cutting tower hardware when elevated |
| From: | J Chaloupka via TowerTalk <towertalk@contesting.com> |
| Reply-to: | J Chaloupka <boltsnutspins@yahoo.com> |
| Date: | Sat, 5 Sep 2015 20:23:55 +0000 (UTC) |
| List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
Mount an abrasive cut off wheel and you are good to go. http://www.homedepot.com/p/Ryobi-18-Volt-ONE-4-1-2-in-Angle-Grinder-Tool-Only-P421/100519983 W4QBQ, JIM _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] DX Engineering, Thomas Noel |
|---|---|
| Next by Date: | [TowerTalk] DX Engineering Negative, Wilson |
| Previous by Thread: | Re: [TowerTalk] DX Engineering, w1yw via TowerTalk |
| Next by Thread: | [TowerTalk] DX Engineering Negative, Wilson |
| Indexes: | [Date] [Thread] [Top] [All Lists] |