Bill -
The rotor fits entirely within the innermost section, nothing hanging out. It's
well clear of the next section when the jam happened.
73, Mike NF4L
> On Aug 16, 2015, at 8:39 PM, Bill Aycock <baycock@mediacombb.net> wrote:
>
> Mike--
> Since this happened just after Rotor work, I would suspect that as the cause.
> Where is the Rotor with respect to the top?
> I would take a close look at the Rotor body for any scratches, etc.
> Bill--W4BSG
>
> -----Original Message----- From: Mike Reublin NF4L
> Sent: Sunday, August 16, 2015 5:44 PM
> To: towertalk reflector
> Subject: Re: [TowerTalk] Binding tower
>
> Anybody know a traveling tower mechanic?
> 73, Mike NF4L
>
>
>> On Aug 15, 2015, at 6:13 AM, Mike Reublin NF4L <nf4l@comcast.net> wrote:
>>
>> I had the HG-70HD down to replace the rotor. When I put it back up, it binds
>> about 3 feet from full extension enough to stall the 24V wheelchair motor
>> that drives a Fulton #3000 winch.
>>
>> I can't see any hang up thru binocs. When I collapse it, and tilt it over,
>> how do I find the jam, and how can I repair it? I don't have enough room to
>> extend it fully when it's horizontal.
>>
>> 73, Mike NF4L
>>
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|