You can put something like this:
https://www.sparkfun.com/products/9669?gclid=COHvxKWbp8cCFQ4paQod9MgLog
. . .connected to the remote PC or perhaps a Raspberry Pi or something.
Or, use a cheap Arduino with ethernet to connect to it. I've seen one of
these gadgets with eight switches but I can't find that link right now. I
have not deployed such a thing myself yet, but I have been looking into
them.
Just google for USB relay box or something similar and they will turn up,
probably eventually find one to meet all your specs. They appear to be
quite commonplace. Some have high DC and AC ratings.
Total cost to deploy should be under 100 dollars unless you go hog wild
with cases and you can have (here) six total devices controlled, either
control lines or even power. So, maybe 20 dollars per switch?
Larry WO7R
On Thu, Aug 13, 2015 at 3:50 PM, Paul Christensen <w9ac@arrl.net> wrote:
> This fall, I will be adding multiple transceivers and amplifiers to a
> remote site. Unlike other web controlled devices, switching between
> amplifiers requires the simultaneous switching of Amp In/Amp Out
> connections. Can anyone suggest an off-the-shelf Ethernet device that will
> switch transceivers and amplifiers through a built-in web server? Even
> better -- a device that will also switch transmit antennas as well as an
> 8-element Hi-Z receive array.
>
> Several years ago, I modified a W8ZR StationPro II (SP-II) with an
> embedded web control card and an optically-coupled interface board The
> SP-II switching device is completely isolated from the web controller. The
> modified controller appears in a QEX article I wrote back in 2011.
> Although that device would work well in this application, I would prefer to
> keep it at my home location. Time constraints prevent me from duplicating
> that effort. I do not require any additional rotator control, AC outlet
> control, etc. That's covered pretty well with plenty of room for expansion.
>
> Again, I'm looking for an off-shelf Ethernet solution. Otherwise, I may
> as well just build another SP-II controller with an internal web control
> board. I see references to 4O3A systems, but it appears much of it is in
> development.
>
> Ideas, anyone?
>
> Paul, W9AC
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|