Rex,
Ask around in your club. Within the CADXA you have some very knowledgeable
guys there.
73/jeff/ac0c
www.ac0c.com
alpha-charlie-zero-charlie
-----Original Message-----
From: john@kk9a.com
Sent: Wednesday, July 22, 2015 7:49 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] 4 square
Typically the antennas are 1/4 WL apart (246/MHz=Ft) in a square. There is
a plethora of information in the ON4UN Low Band DXing book and probably also
in the ARRL Antenna book. If you are using a commercial controller it will
likely also have some layout instructions.
John KK9A
To: Towertalk Reflector <towertalk@contesting.com>
Subject: [TowerTalk] 4 square
From: Rex Turvin via TowerTalk <towertalk@contesting.com>
Reply-to: Rex Turvin <turvin2009@yahoo.com>
Date: Wed, 22 Jul 2015 22:54:56 +0000 (UTC)
I am getting ready to build my 1st 4 square. Can someone direct to to a good
source of information that will help me in the correct placement of the
individual verticals? Also i am wanting to use raised radials.Any help is
appreciated.Thank you in advance73 NR6M
ex: KF7NMD
Sincerely,
Rex Turvin
Vice President CADXA
www.nr6m.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|