To: | towertalk@contesting.com |
---|---|
Subject: | [TowerTalk] Current Choke for Ladder Line |
From: | Hans Hammarquist via TowerTalk <towertalk@contesting.com> |
Reply-to: | Hans Hammarquist <hanslg@aol.com> |
Date: | Tue, 12 May 2015 14:01:29 -0400 |
List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
Gentlemen, I have seen many articles how to build and/or buy common mode chokes for coax cables but I don't remember any articles how to build (or buy) and choke for a 400 ohm ladder line. The common mode current on a ladder line is causing the same problem as a common mode current on a coax. i have a choke between my tuner and radio which reduced noise quite good but wonder now how much RF power I radiate and signal I receive from the CM current in the feeder to my OCF dipole. Any ideas/comments? Hans - N2JFS _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | [TowerTalk] WTB: Comtek COM-PVS-2A control console or schematic (controller), Mike Smith VE9AA |
---|---|
Next by Date: | Re: [TowerTalk] Current Choke for Ladder Line, Jim Brown |
Previous by Thread: | [TowerTalk] WTB: Comtek COM-PVS-2A control console or schematic (controller), Mike Smith VE9AA |
Next by Thread: | Re: [TowerTalk] Current Choke for Ladder Line, Jim Brown |
Indexes: | [Date] [Thread] [Top] [All Lists] |