I use a tube top section with the rotor on a shelf just below the tube.
That way I don't need a bearing. When I need to change a rotor, I clamp a
U bolt at the top of the tube to hold the mast.
Chuck W5PR
On Sat, Apr 11, 2015 at 3:46 PM, Chuck Dietz <w5prchuck@gmail.com> wrote:
> Yes
>
> Chuck W5PR
>
> On Sat, Apr 11, 2015 at 3:38 PM, Mike Reublin NF4L <nf4l@comcast.net>
> wrote:
>
>> Can it be put thru the side without cutting a brace?
>>
>> Mike NF4L
>>
>> > -----Original Message-----
>> > From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of
>> Drax Felton
>> > Sent: Saturday, April 11, 2015 13:45
>> > To: Rex Turvin; Towertalk Reflector
>> > Subject: Re: [TowerTalk] Yaesu G-2800DXA
>> >
>> > Absolutely it will fit
>> >
>> > Sent from Outlook
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|