Towertalk
[Top] [All Lists]

[TowerTalk] Loosening Rusted Hardware

To: "Towertalk" <towertalk@contesting.com>
Subject: [TowerTalk] Loosening Rusted Hardware
From: "Don W7WLL" <w7wll@arrl.net>
Date: Sat, 11 Apr 2015 11:06:53 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Patrick, is this the University report on alternatives to WD-40 you were referring to?? This was also some info an a mechanical mag but I didn't keep it.

https://www.engineeringforchange.org/news/files/ENGR103-WD40Alternative-FinReport.pdf

Don W7WLL

-----Original Message----- From: Chris
Sent: Friday, April 10, 2015 12:19 PM
To: towertalk@contesting.com reflector
Subject: Re: [TowerTalk] Zerk fitting for MA-40

Left handed drills have the battery polarity reversed as well...requires a special charger. :-) Also don't forget to have a metric crescent wrench available to take out the remains of the zerk fitting when it gets loosened up.

Chris
KF7P






On Apr 10, 2015, at 1:04 PM, TexasRF--- via TowerTalk wrote:

Patrick, assuming ATF means automatic transmission fluid, a wiki search
shows there are more than ten different flavors in use. Wonder which one is
recommended?

On the subject of left handed drill bits: what would the intended use be?
Drilling left handed holes? Use with left handed drill motor? Having
survived thus far without needing one I am wondering what I have missed out on. Since easy out tools are readily available and most likely a lot more robust
than left  handed drill bits seems the actual need is not great. Probably
less expensive as  well and I see one tool fits several size bolts.

Now that it has come to light that drill bits can be used in place of an
easy out tool, it seems that there will be no need to buy an easy out tool
for reverse threaded bolts; a regular drill bit will work for that purpose.

Yea, it is a slow day here!

73,
Gerald K5GW



In a message dated 4/10/2015 1:41:01 P.M. Central Daylight Time,
patrick_g@windstream.net writes:

An  extensive university (I forget which one) engineering department
study  tested penetrating oil products like Rust Buster, WD-40, etc.
None,  including the expensive ones beat a 50-50 mix of ATF and Acetone.

I  mixed up some and have been getting good results.  I recommend you try
this mix before you give up on Easy-Outs and their ilk.  Left handed
drill bits work in some instances but be careful with the smaller sizes
as when they break off they are in the way of trying other  approaches.

Good luck to you.

Patrick NJ5G


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>