> If you have, how does your antenna perform with your new element
> dimensions versus the factory default ones?
Unless you can derive an appropriate dielectric factor for the tubes
used in your SteppIR, the element lengths derived from any modeling
program will be too long. Years ago K7IR told me they worked with model
frequencies higher than the actual operating frequency and then
tweaked the lengths by a uniform percentage to place the rear null
on the target frequency. In other words their lengths were derived
empirically on the antenna range because the dielectric factor varied
from band to band.
73,
... Joe, W4TV
On 2015-04-08 4:05 PM, William Osborne wrote:
Does anyone have experience modelling an antenna in EZNEC and then loading
those elements into a SteppIR antenna (I am using 4E so that is of most
interest). If you have, how does your antenna perform with your new element
dimensions versus the factory default ones? Mine does not seem to resonate
at the same frequency as the model, so I think a correction factor is
required to the EZNEC model elements?
Bill--K5ZQ
***********
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|