Herb,
Assuming the tower is guyed, seems to me the easiest thing to do would be to
use a short flat top section on the 45G and a flat base plate for the 25G and
just bolt them together with a few bolts.
73...Stan, K5GO
Sent from my iPad
> On Jan 27, 2015, at 10:17 AM, Herbert Schoenbohm
> <herbert.schoenbohm@gmail.com> wrote:
>
> One of my towers starts out with 40 feet of Rohn 45 and I would like to
> continue with another 20 feet with Rohn 25. (I have the proper top section
> for Rohn 25 and rotor plate) Currently I use large clamps on each leg with
> the Rohn 25 nestled a few feet inside the Rohn 45. My question: Is there a
> commercially made reduction section available anywhere that can do this? I
> see one in the Rohn catalog for 55 to 45 but not 45 to 25. Please let me
> know if such a device is reduction section exists.
>
>
> Herb Schoenbohm, KV4FZ
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|