Towertalk
[Top] [All Lists]

[TowerTalk] Practical Grounding at reasonable cost.

To: "Towertalk@contesting.com" <towertalk@contesting.com>
Subject: [TowerTalk] Practical Grounding at reasonable cost.
From: "Roger (K8RI) on TT" <K8RI-on-TowerTalk@tm.net>
Date: Tue, 20 Jan 2015 03:46:20 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
The Thread "RF Grounding is a myth" has a lot of useful information as well as good information, but useless for hams in general.

A "Franklin System" is lightening rods connected to grounds! They can be elaborate or simple. Usually to ground rods and often to a perimeter ground with ground rods every 20 feet when using 10' rods, not just at the corners. These are widely used in industry. You will see them on the top corners and peaks of buildings and towers in chemical plants. Our barn had such a system and it was built decades before I was born. Somewhere I have some photos of "the Barn Raising". The only source of power, other than "man power" are the teams of work horses visible.

The UFER is probably the largest, effective ground most hams can afford. Tying the rerod together in the tower foundation and tying it to the station ground would likely give a more efficient and effective ground than most stations have. Remember, no leads should penetrate the concrete below grade. Through conduit is normally an exception. Large copper grounds that leach are again are effective, but impractical for most hams.

It should be noted that the concrete in grounds also leaches ions into the surrounding soil, slowly increasing its conductivity. (see Wikipedia on UFER grounds) A few ground rods encased in concrete would likely increase the efficiency far beyond the practicality of more ground rods. The ones I have seen are formed by using a large cardboard tube as a form to cast the ground rod in concrete. (remove the form before planting the ground!) An auger digs a hole of the proper diameter to the proper depth and the encased rod is lowered into place. Not cheap, but very effective. Not all that expensive when compared to the number of rods and cable they replace.

I'm half tempted to replace my ground system with a UFER ground and a half dozen encased 10' ground rods on a perimeter ground. Still, I can not get under the 30 foot wide garage apron. At $3.00 a pound for scrap copper, that's more than what I paid for that cable when it was new. <:-)) Impractical to dig up the current system? Yup, but it's still tempting.<LOL>

The perimeter ground is good, but pricey. In general, I'd say ground rods longer than the NEC required 10' are not going to gain much, if anything, and driving even 10 footers can be problematic let alone, longer rods...

Remember: These ground systems are for safety. They have nothing to do with RF, or how good your antennas work.

--

73

Roger (K8RI)


---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>