TT:
The referenced grout is THERMALLY-conductive according to the link.
Says nothing about its electrical conductivity. This material is used to
grout the vertical bore holes that contain the heat transfer loops of a
ground-source heat pump. Check out "vertical" at
http://energy.gov/energysaver/articles/geothermal-heat-pumps .
73 de
Gene Smar AD3F
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of
Mickey Baker
Sent: Monday, January 19, 2015 12:00 AM
To: Ken
Cc: towertalk@contesting.com
Subject: Re: [TowerTalk] w7ekb & ground rods
Special phone company grout, no doubt. :-)
http://www.baroididp.com/idp/products-applications/products/grouting-product
s/idp-550.page
On Sun, Jan 18, 2015 at 11:43 PM, Ken <wa8jxm@gmail.com> wrote:
> Would grout provide an adequate electrical path to the rock ground?
> Does the rock itself provide an electrical ground?
>
> Ken
>
> > On Jan 18, 2015, at 11:05 PM, Mickey Baker <n4mb@arrl.net> wrote:
> >
> > The solution was to
> > deploy a construction crew with a 48" x 1 1/4" hammer drill bit, to
> > drill two holes to a depth of 48" and attempt to drive the rod
> > beyond that. If that worked, the hole was grouted shut around the
> > rod. If it didn't work, the rod was to be cut to 48" and each end
> > grouted into the two holes,
> both
> > connected to the booth with #6 solid copper.
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|