Ken,
So far I have not experienced the conditions you ran into. If I did,
I would drive the rod at an angle or bury it in a trench.
I will reach out the gentleman I quoted and see what is position is for
situations as you describe.
Martin
On 1/18/2015 8:00 PM, Ken wrote:
If I may ask, what’s the “appropriate tool” when you have a rock layer 40”
down? i tried a hammer drill, waste of time. I rented an SDS-MAX hammer and I got one in all the way,
four others only made it most of the way. So what is the recommendation?
Ken WA8JXM
On Jan 18, 2015, at 7:46 PM, Martin A Flynn <maflynn@theflynn.org> wrote:
Ran this past one of the code enforcement guys in the county. Surprising
response:
"We make you buy a UL listed panel board and breakers - what makes you think
you can build a grounding system that is equal to UL *and* be able to prove it in
court if there is
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|