| To: | towertalk@contesting.com |
|---|---|
| Subject: | Re: [TowerTalk] How to solder aluminum braid coax cable ? |
| From: | Jim Brown <jim@audiosystemsgroup.com> |
| Reply-to: | jim@audiosystemsgroup.com |
| Date: | Fri, 16 Jan 2015 13:50:31 -0800 |
| List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
On Fri,1/16/2015 12:21 PM, Bill Turner wrote: I would suggest not soldering it. Crimp it instead. Snap N Seal makes good quality BNC compression connectors for various incarnations of 75 ohm Al foil/braid shielded cables. Size matters -- be sure to buy the right connectors to match the cable. You'll also need a cable stripper and compression tool that fit the cable. 73, Jim K9YC _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] How to solder aluminum braid coax cable ?, Bill Turner |
|---|---|
| Next by Date: | Re: [TowerTalk] Tower installtion question, Ed Sawyer |
| Previous by Thread: | Re: [TowerTalk] How to solder aluminum braid coax cable ?, Bill Turner |
| Next by Thread: | Re: [TowerTalk] How to solder aluminum braid coax cable ?, Roger (K8RI) on TT |
| Indexes: | [Date] [Thread] [Top] [All Lists] |