Pat:
In a similar vein, the Trylon Titan series of SS towers has diagonal
bracing. It's not difficult to climb (I go up by straddling a leg rather
than in the middle of a tower face.) However, working on a cross-brace for
any length of time can be tiring. I always wear boots with good ankle
support. If you're able to work at a level where you can stand on one of
the flat angle pieces that supports a rotator shelf, then it's very
comfortable and secure-feeling.
In any case, the Trylon Titans are good medium-duty towers that you
ought to look into.
73 de
Gene Smar AD3F
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Kim
Elmore
Sent: Saturday, January 03, 2015 9:18 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Fast, cheap, and or good... Pick two.
I have an HDBX48 that has been in service (by now) for nearly 30 years.
Mine has been holding 18 sq feet plus 8 ft of 2 in mast for that length of
time with measured winds up to 86 MPH. It's hell-for-stout but VERY
uncomfortable to climb due to the X-bracing.
Kim N5OP
On 1/3/2015 5:04 PM, Patrick Greenlee wrote:
> In my pre-retirement days I was often in the fast, cheap, and or good;
> pick any two game.
>
>
> I would like to solicit the opinions of the TT brain trust regarding
> the best tower to avoid climbing. I've been there, done that and as
> the years roll by it is less of an attraction. I'm thinking unguyed,
> at least above the top of the lowest section and probably either
> crank-up, tilt-over, or crank-up/tilt-over.
>
>
> I have a 2 section tilt-over/crank-up with 3 way guys on the lower
> section that with tube mast goes above 50 ft and handles light weight
> moderate wind loading antennas (hex beam) but it is NOT going to get a
> large heavy antenna and rotor (when exactly did rotors become
> rotators? (Maybe about the time all problems became issues?)
>
>
> I don't want to over buy (money is an issue if not a problem) but
> don't want to under buy and regret it later. (Short sighted decisions
> made in haste can be regretted at your leisure.)
>
>
> Then there is Galvanized steel vs aluminum or??
>
> I want a design that will take a minimum of 20 sqft of antenna
> windage, 250 lbs antenna weight before rotor and mast, and preferably
> no guys but a guyed bottom section is a possibility.
>
> Ideas, suggestions?
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
--
Kim Elmore, Ph.D. (Adj. Assoc. Prof., OU School of Meteorology, CCM, PP
SEL/MEL/Glider, N5OP, 2nd Class Radiotelegraph, GROL)
/"In theory there is no difference between theory and practice. But, in
practice, there is." //- Attributed to many people; it's so true that it
doesn't matter who said it./
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|