My problem coax jumper was solit not foam and it was only bad for a
couple inches. I cut some up to check.
Patrick NJ5G
On 12/16/2014 9:07 AM, K7LXC--- via TowerTalk wrote:
I saw some coax a few years ago where the center conductor was not
entirely in the middle of the insulator. Bad molding? It was RIGHT up
near the shield in some spots and centered in others... If I remember
correctly it was a foam dielectric...
A big problem with foam dielectric is that it'll cold flow under the right
conditions. It's a problem with wound coax baluns.
Cheers,
Steve K7LXC
TOWER TECH
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|