Towertalk
[Top] [All Lists]

Re: [TowerTalk] Balun for Quad

To: Chuck Dietz <w5prchuck@gmail.com>
Subject: Re: [TowerTalk] Balun for Quad
From: Robie Elms <ruler55@gmail.com>
Date: Thu, 27 Nov 2014 07:26:27 -0600
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Chuck,

I built a 1:1 current balun (choke) with one  2.4 " OD #31 core following
information published by K9YC. I used a PVC box approximately 4.5"
X4.5"X2.5" as a housing,  installed a SO239 a used ss hardware as terminals
for connections to the antenna.  It works well for my situation - wire
antennas and low power.  There are a number of suppliers with similar
commercial products.

I hope this stimulates some positive ideas!

Robie - AJ4F


On Thu, Nov 27, 2014 at 7:10 AM, Chuck Dietz <w5prchuck@gmail.com> wrote:

> I hope everyone is not burned out on the balun thread.  I am planning to
> resurrect my 4 element triband quad.  It will be in the "diamond"
> configuration and fed at the bottom spreader.  Obviously I need the
> smallest, lightest balun I can get.  I have used the "DU" long commercial
> baluns in the past, but I am wondering if I can just wind a balun
> transformer on a core and be much lighter and less wind resistance?
>
> Thanks in advance for your thoughts,
>
> Chuck W5PR
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>