To: | towertalk@contesting.com |
---|---|
Subject: | Re: [TowerTalk] Fwd: Bulkhead feed-through. |
From: | "Roger (K8RI) on TT" <K8RI-on-TowerTalk@tm.net> |
Date: | Fri, 21 Nov 2014 05:35:42 -0500 |
List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
On 11/20/2014 5:58 PM, Hans Hammarquist via TowerTalk wrote:Mine are inside NEMA boxes, with a 3 to 4" tube into the building. The tube is filled with expandable foam. Keeps critters and weather out. http://www.rogerhalstead.com/ham_files/cablebox.htm Check the 4th photo down. It's since been replaced with a larger box and the conduit filled with foam. 2nd photo down shows the foam filled ends of the conduit headed for the basement. OTOH Weather proof the connectors if moisture is a problem.Those big boxes on the tower have a LOT of connections. About 25, give or take a few. Moisture has never been a problem yet! Cables from the boxes to antennas either go through glands, or weather proof feed throughs. The two RG-59 cables to the satellite dish pass through the box as well. They use type F bulkhead connectors. 73 Roger (K8RI) Well, mine isn't. :( -----Original Message----- From: Ron Young <youngron@verizon.net> To: Hans Hammarquist <hanslg@aol.com> Sent: Thu, Nov 20, 2014 5:42 pm Subject: Re: [TowerTalk] Bulkhead feed-through. Usually the bulkhead is on stand-offs so the plate is off the outside wall. Only coax goes thru the wall. There should be no vapor going thru the coax so no problem. Ron W8RJL Sent from my iPhoneOn Nov 20, 2014, at 5:34 PM, Hans Hammarquist via TowerTalk<towertalk@contesting.com> wrote:I have a grounded, metal plate that carries all my bulkhead connectors fromthe outside to the inside. No big deal except: I have wrapped the outside of the connectors with water tight tape.Consider that the temperature is lower outside than inside (Vermont) I amafraid that I will have water buildup on the connectors on the outside as vapor easily can get through from the inside.Comments! Have anyone have had a problem with this before? Do I have to getguarantied water tight bulk, feed-through connectors?_______________________________________________73 de, Hans N2JFS _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk_______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk -- 73 Roger (K8RI) _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TowerTalk] Fwd: Bulkhead feed-through., Ron W8RJL |
---|---|
Next by Date: | Re: [TowerTalk] [Bulk] Re: Cordless solder irons, ve4xt |
Previous by Thread: | Re: [TowerTalk] Fwd: Bulkhead feed-through., EZ Rhino |
Next by Thread: | Re: [TowerTalk] TowerTalk Digest, Vol 143, Issue 58, Matt B via TowerTalk |
Indexes: | [Date] [Thread] [Top] [All Lists] |