I have a MA770, 70 ft telescoping mast with a Ham 4 rotator mounted at the
base. My problem, if I have any winds over, say 10 mph, the Ham 4 stalls
and will not rotate my Force 12 10m-17m multi element yagi, 24 ft boom, 7.2
st.. The lack of rotation has been getting worse over the past 6 months. I
did check the voltage at the control box across the starting cap. It seems
to be near 24 V. I have also pumped a lot of grease into the lower bearing
that supports the weight of the rotating mast.
My question, and I have searched, what is the difference in
starting/running torque between the Ham 4 and TailTwister? At the time the
MA770 was designed, the Ham 4 was the largest readily available rotator. I
do have a TailTwister that I could install, but I will have to modify the
mounting plate hole pattern. Is it worth the effort?
Any other ideas or comments?
Ray,
N6VR
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|