Tek has made adaptors for BNC connectors with internal
amplifiers/attenuators. These were used with the older probes. My 425 uses
two P1001S (universal) probes that may be switched between 1:1 and 10:1
attenuation.
73, Keith NM5G
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Roger
D Johnson
Sent: Friday, September 12, 2014 4:14 PM
To: Towertalk Reflector
Subject: [TowerTalk] Tektronix 1502
I'm fixing up and calibrating a 1502 I put together from 2 that were bad.
The manual keeps referring to an "adapter BNC to probe" Tektronix p/n
013-0130-00. I have no idea what this is! The connector on the 1502 is BNC
as is the connector on the P6106 probe. I've looked through old Tek catalogs
and cannot find that part number.
Help!
73, Roger
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|