I believe it was ON4UN that suggested running cables inside the tower would
help. I ran my cables inside but have not shunt fed my tower yet so I don't
know if that will really help.
73, Larry W6NWS
-----Original Message-----
From: LB3RE LJ3RE Stein-Roar Brobakken
Sent: Wednesday, August 27, 2014 8:35 AM
To: Pete Smith N4ZR
Cc: topband@contesting.com
Subject: Re: Topband: Shunt feeding tower
How is inteference on rotor or relay boxes?I thinking 1kw generate magnetic
radiation into cables ??? How u solve this guys ?? Tnx
---Sent by iphoneLB3RE LJ3RE K3RAG ex: LA6FJAwww.lb3re.com ~ Rag ~ Stein
Roar Brobakken
e-mail:post@lb3re.comhttp://la5o.wordpress.comwww.contesting.no
Reading about 3-wire cages and the like, I feel a serious case of shunt
envy. Mine is a single wire about 18 inches from one corner of my Rohn
25, connected to the tower at about 50 feet. I used an omega match with
a couple of 3 KV transmitting variables, because my tower is quite tall
for 160 (97 feet with 3 yagis, 2 on top) and I could not find a 50-ohm
point.It was absurdly easy to adjust and seems to work quite well at 100
watts. I'm sure there are better solutions (including Herb's), but this
was really simple.
73, Pete N4ZR
Check out the Reverse Beacon Network at
http://reversebeacon.net,
blog at reversebeacon.blogspot.com.
For spots, please go to your favorite
ARC V6 or VE7CC DX cluster node.
On 8/26/2014 5:12 PM, Don wrote:
I would like to get on 160 this question most likely has been asked a 1000
time but I need information as how or can I shunt feed my 55 ft rohn 45 .
Don
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|