Date: Tue, 26 Aug 2014 08:47:33 -0700
From: Grant Saviers <grants2@pacbell.net>
To: "john@kk9a.com" <john@kk9a.com>, towertalk@contesting.com
Subject: Re: [TowerTalk] [Bulk] Re: 2" OD Long Masts
Much cheaper than 4130 is the "1026" alloy A513 72,000psi yield. I see
onlinemetals.com has some 0.120" wall x 2.25" od which would make a
great sleeve for 2" masts. They will get full lengths if you ask as
they are owned by Thyssen-Krupp or go direct to a service center.
Grant KZ1W
## 1026 is DOM.... drawn over mandrel. It comes in any where from 72 ksi...
all the way up to 89 ksi.
## he probably has a 2 inch bearing setup on his tower......so a 2.5 inch OD
sleeve would be hard to implement. He would be better off to just use an
inner sleeve,
that just slides in..with minimal slop. Something in the range of .1875 to
.250 thick.
## I would suggest running all of this through the free arrl mast software
1st. Then u
know exactly what you are dealing with. I suspect you would only have to
re-enforce the lower portion of the mast... like from the rotor..... to about
.666
the length of the mast. The last few feet at the very top would not have to
be
re-enforced.
Jim VE7RF
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|