Ketchup, I seen this on Ricks Restoration.
Ed N5DG
On 8/2/2014 8:31 AM, Gedas wrote:
As much as I hate to admit it, at times I have been guilty of leaving
rotor cables or even coax outside unprotected from the rain and snow.
Later on, wanting to put it to some use and after stripping off some
insulation, I find that the surface of the copper conductors have been
tarnished with a nice black coating. The tarnish makes it impossible
to solder to even with an acid core flux. Other than physical
abrasion, does anyone have any tricks or solution/chemical that will
remove that tarnish?
Gedas, W8BYA
Gallery at http://w8bya.com
Light travels faster than sound....
This is why some people appear bright until you hear them speak.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
---
This email is free from viruses and malware because avast! Antivirus protection
is active.
http://www.avast.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|