George, I know that SS is considerably weaker than the high strength alloy
bolts in the OR2800. I have an OR2800 on the ground and it does not appear
practical to ream the holes for larger bolts. I would drill several
additional holes and use SS 3/8 bolts. they can be obtained from
Mcmaster-Carr
73, Dan, N5AR
On Mon, Apr 21, 2014 at 6:15 AM, <Georgek5kg@aol.com> wrote:
> I need to replace the rotor-to-mast-clamp bolts on my OR 2800. They are
> 3/8-24 x 4" Grade 5 bolts zinc plated, and are totally rusted.
>
> Since I live on salt water, I would prefer to replace them with stainless.
>
> My question is: Is there any problem replacing the Grade 5, zinc plated
> bolts with stainless in this application? Also, what is a good source for
> 3/8-24 x 4" ss bolts.
>
> Tnx, George
>
> George Wagner, K5KG
> Sarasota, FL
> 941-400-1960 cell
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
--
Dan Hearn
N5AR
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|