You don't mention what is slipping - rotator to mast or boom to mast.
For boom to mast and element to to boom clamping I think the DX
Engineering cast saddle clamps on an appropriate sized 6061 plate will
hold until the antenna bends.
Grant KZ1W
only a DXE customer
On 4/19/2014 9:00 AM, Joe Barnes wrote:
Does anyone have a suggestion other than pinning or the Tennadynes Slip Knott
for keeping antennas from moving around in the wind? All of my aluminum has
sprouted at over 100 feet in the air and is a bear to keep straight in these
winds that we get here in Florida in some of these storms. Thank you for your
input.
Joe N4JBK
---
This email is free from viruses and malware because avast! Antivirus protection
is active.
http://www.avast.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|