Congratulations Stan on being acquired by DX Engineering. I just noticed
this last week while searching for aluminum tubing.
The Cycle 24 clamps will work with 1/4 plates however there is not much
room for a washer. They are a bargain, the galvanizing is excellent and
they are good for certain applications.
I have also used many DX Engineering saddle clamps with excellent results
and also a few stainless steel muffler clamps purchased from Paul Sergi's
other company Summit racing.
John KK9A
To: K0YR - Thomas Rieff <k0yr@tomrieff.com>
Subject: Re: [TowerTalk] Saddle Clamps
From: Stan Stockton <wa5rtg@gmail.com>
Date: Mon, 7 Apr 2014 18:30:45 -0500
Tom,
DX Engineering acquired Cycle 24 Antenna Products recently and has the
galvanized clamps previously offered by Cycle 24. If the thickness of
whatever
you are attaching is 3/16 (maybe as much as 1/4 inch) they will work very
well
- 5/16 inch diameter bolts and flat washer nuts - all galvanized and not too
expensive. I have some 200-300 pound antennas that have been held up on side
mounts with these for many years.
73...Stan, K5GO
Sent from my iPad
> On Apr 7, 2014, at 6:19 PM, K0YR - Thomas Rieff <k0yr@tomrieff.com> wrote:
>
> What is a good source for some 1 1/4" saddle clamps???
> In the process of building something that will be secured to a Rohn 45G
> tower.
> Your help is appreciated.
> Tom, K0YR
>
> K0YR
> Thomas Rieff
> 2059 Sundance Lane
> North Mankato, MN 56003
> (507) 381-0660 Cell
> (507) 388-4702 Home
> (320) 629-2530 Pine City
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|