Towertalk
[Top] [All Lists]

Re: [TowerTalk] New windows versus my antenna wiring

To: Steve <steve65@suddenlink.net>
Subject: Re: [TowerTalk] New windows versus my antenna wiring
From: Joseph or Ruth Patrick <hdmc38@bellsouth.net>
Reply-to: Joseph or Ruth Patrick <hdmc38@bellsouth.net>
Date: Mon, 7 Apr 2014 08:10:17 -0700 (PDT)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
 You can buy or build an aluminum panel to fit your particular window where you 
want the feed lines to come thru. When I had my old windows I made a sketch  
and took it down to the sheet metal shop and they made an  aluminum panel per 
my drawing. I then fitted the panel on the bottom of the window and screwed the 
panel to the frame. Now we have replaced all of the windows in the house with 
Impact resistant windows. I live in Florida so if your replacing the windows it 
only makes sense to do it this way. I had another panel made and fit it tightly 
in the bottom the new window. No screws this time. I put some strip foam sealer 
on the top and bottom of the panel first. The I closed the window down tight 
and installed some burglar clips that clamp onto the frame. That holds the 
window down tight so it can't be easily opened. It has worked for me for 11 
years now. YMMV Good Luck.

73 DE K4XZ Joe Patrick
God Made Man
Sam Colt Made Them Equal
 

________________________________
 From: Steve <steve65@suddenlink.net>
To: TowerTalk <towertalk@contesting.com> 
Sent: Monday, April 7, 2014 9:15 AM
Subject: [TowerTalk] New windows versus my antenna wiring
  

Hi all,

I have one open wire feeder and a couple of coaxial cables coming into 
my basement radio shack. Many years ago I removed the glass from the top 
pane of a window and replaced the glass with plexiglass. I drilled the 
plexiglass for feed thru insulators for the open wire and holes for the 
coaxial cables.

I would like to replace the 5 windows on that side of the house, which 
includes the window with the plexiglass antenna cable entrances. The 
existing wooden-frame windows with a single pane of glass will be 
replaced with double-paned, energy efficient double-hung windows.

How do I get my antenna wires into the house after the newer windows are 
installed? The newer windows do not lend themselves to the plexiglass 
scheme in use with the existing window. I would prefer not to drill 
holes in the basement wall -- I want to sell this house eventually 
(that's one reason for replacing the windows in the first place).

One thought I had is to lower the upper half of the new window about a 
foot and insert a piece of plexiglass at the top of the window. Buttress 
the upper half of the new window up against the plexiglass. Seal as 
necessary with polyurethane foam insulation. One problem with that idea 
is that the upper section of the window can be lowered from the outside 
-- not very secure.

Any ideas as to how to get my open wire feeder and a few coaxial cables 
through the wall after the new windows are installed while not damaging 
the walls of the house or the new window?

Thanks.

Steve, K8JQ
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>