Tapping copper, particularly for studs isn't that big an issue. What you do
make sure you are thick enough for 3 threads, and use NC threads, and put in
studs, and et the studs take any abuse
I could see copper being a problem, have to think about that, or just use
brass/bronze etc
On 3/20/2014 Mike Fahmie wrote:
> I had originally replied to KG2V's query offlist, but after reading
> other replies I decided to post my reply to the entire list to share
> my concerns about using Aluminum in this application.
--
Charlie
www.baysidephoto.com
www.thegallos.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|