Perhaps you would use some product found in the link, or use their example and
craft it yourself.
http://www.penningerradio.com/
The radials could be attached to a non metalic ring the inside diameter of
which would be large enough to go over the largest section of the mast,
enabling it to be positioned at your desired height for use and then lowered to
the ground for tilting the tower/mast.
JIM, WD8QBQ
________________________________
On 1/22/2014 9:17 AM, Larry Banks wrote:
It will be sitting on a 10 foot metal mast.
I am looking for ideas for mounting the driven element.
I want to be able to tilt the vertical over without effecting the
radials. Obviously, the radials and driven element must not be
electrically connected to the mast or each other. The mounting method
should not effect the radiation pattern -- implying that it cannot be
fabricated out of metal. I also want to be able to raise the vertical
myself without my XYL needing to help me. I plan on fabricating this
myself, only purchasing raw materials.
>
> 73 -- Larry -- W1DYJ
>
Use a fixed 10 foot mast to hold up the radials.
Use another 10 foot mast to hold up the vertical.
The vertical is mounted to its mast using
a piece of PVC pipe as an insulator.
Or alternately, the entire mast is PVC pipe.
The mast for the vertical has a hinge plate at the bottom
to allow it to tilt down at an azimuth that falls between
radials. You can walk up the vertical. Once it is
up, you clamp the hinged 10 foot mast to the fixed
10 foot mast to hold it up.
Summarizing: the entire 43 foot assembly consisting
of a 33 foot vertical on top of a 10 foot mast pivots
from horizontal to vertical.
No, I don't have pictures of this.
Rick N6RK
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|