Remove the u bolts. I think that the plate has to go in at the joint
between sections and then taps with a rubber mallet will get the plate
horizontal and then it can moved up inside the tower
Practice on a joint at ground level first. Then you wil be ready to work at
height. It works like that on the Rohn 45 tower sections
Mark N1UK
----- Original Message -----
From: <TexasRF@aol.com>
To: <aa5fx@yahoo.com>; <towertalk@contesting.com>
Sent: Tuesday, 15 October, 2013 10:12 AM
Subject: Re: [TowerTalk] Rotor plate
Most Rohn top sections have an area that diagonal rungs are not present.
That is the intended location of the rotator and plate.
Does your top section have such an area?
73,
Gerald K5GW
In a message dated 10/15/2013 6:30:39 A.M. Pacific Daylight Time,
aa5fx@yahoo.com writes:
I am trying to put a rotor plate in25ag top
Howdoiget it on
Sent from my Samsung Galaxy Express™, an AT&T LTE smartphone
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|