Re: [TowerTalk] Connecting Tower to Ground Rod

["Roger (K8RI) on TT" <K8RI-on-TowerTalk@tm.net>]

On 10/9/2013 8:54 AM, GARY HUBER wrote:
> Aluminum ground lug on the tower leg bolt, #4 or #6 solid copper to 
> the ground rod and a #4 or #6 to the MDP or system ground IAW with 
> NEC. All grounds must be bonded together.
> 73 ES DX,
> Gary -- AB9M
>
> -----Original Message----- From: Michael Warren
> Sent: Wednesday, October 09, 2013 5:50 AM
> To: towertalk@contesting.com
> Subject: [TowerTalk] Connecting Tower to Ground Rod
>
> What standardized method can I use to connect the base of a Rohn 25 to a
> ground rod driven into the ground very near the base?
And I'd make that a ground system/network if there is any height to the 
tower
A single ground rod doesn't provide a lot of protection.   I'd consider 
1 rod about 3 feet out from each leg a minimum for a 50-60 foot tower 
with a tribander on top.  Check your code for requirements.
They now typically require two rods at the house entrance. We went to a 
200A underground feed about 10-12 years ago and had to replace the old, 
single rod with two about 3 to 5 feet apart IIRC.  "I think" there are 
code requirements for towers as well
73,

Roger (K8RI)
> Michael Warren
>
> Ka5rej
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk