8.5 inches. Although, I have always had to shim it up a bit (maybe 0.25
inch) with washers at the mounting screws to keep the terminal strip off the
shelf.
73, Larry W6NWS
-----Original Message-----
From: James Setzler
Sent: Thursday, September 19, 2013 11:35 AM
To: towertalk@contesting.com
Subject: [TowerTalk] HAM IV Height
Greetings,
I'm replacing a HAM IV with a Yaesu G-800GXA and concerned about the depth
of the mast into the rotor housing.
What is the dimension on the HAM IV from the mounting plate to the point
that the bottom of the mast rests?
73 James K1SD
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|