Re: [TowerTalk] TowerTalk] Rotator control program to slave two rotors??

["David Jordan" <wa3gin@comcast.net>]

Yes, works good.

----- Original Message ----- 
From: "Tom-W3FRG" <w3frg1@gmail.com>
To: <towertalk@contesting.com>
Sent: Thursday, September 05, 2013 3:11 PM
Subject: [TowerTalk] TowerTalk] Rotator control program to slave two 
rotors??

> PstRotator is set up to handle multiple rotors.
> Ref page 34 of the Operating manual.
> To create multiple instances, just go to Help / Create Multiple Instances.
> From there you can create/delete another 7 instances.
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk