Towertalk
[Top] [All Lists]

Re: [TowerTalk] Rotator control program to slave two rotors??

To: Ken Beals <k6mr@outlook.com>, Tower Talk <TowerTalk@contesting.com>, Jay Kesterson <k0gu@verinet.com>
Subject: Re: [TowerTalk] Rotator control program to slave two rotors??
From: Scott <scottw3tx@verizon.net>
Date: Wed, 04 Sep 2013 23:24:23 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Check PST Rotor

http://www.qsl.net/yo3dmu/index_Page346.htm

73, Scott W3TX

On 9/4/13 11:16 PM, "Ken Beals" <k6mr@outlook.com> wrote:

>I have not personally used the feature, but if you don¹t mind using a
>logging program as the controller N1MM Logger will control multiple
>rotators at the same time. You just need to define the antennas as a
>stack and it will turn the stack with a single command.
>
>
>Ken K6MR
>
>
>
>From: Jay Kesterson
>Sent: Wednesday, 4 September, 2013 20:12
>To: Tower Talk
>
>
>   Green Heron controllers are very nice. I have two of them on another
>array. However what I don't have at the moment is the money to buy more.
>I can, of course, use two different rotor controller programs to
>separately turn the rotators from the same PC. Just surprising someone
>hasn't thought, as far as I can tell, of doing a slave of two computer
>capable rotators with one piece of software. Perhaps someone out there
>still has an answer?
>
>73,  Jay  K0GU
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>