I have just erected a new HDBX 40 in place of my 30 year old HBX 48,
sacrificing 8' of height to gain some strength and load capacity (and peace of
mind!). The stock rotator plate allows 2' of mast below the top plate and I
will be using the heavy duty Yaesu thrust bearing (along with the Yaesu heavy
duty 2800 rotator plus the absorber plate). I have added steel angle braces
to reinforce the rotator plate.
I'm looking at using a 15' chrome/steel 2" mast (in place of my previous 9'
mast), so 13' of the mast would extend above the tower. The mast would support
a TX38 tribander just above the top plate, a 6 m beam half-way up, and a 40m
rotatable dipole near the top, 12' above the top tower plate and the thrust
bearing. The mast, of course, is very heavy, weighing around 75lbs. The
tribander weighs 40lbs and is 5 ft2; the 6 m. beam weighs 10lbs and has 1.5
ft2; the dipole weighs 10lbs and has 0.5 ft2.
Is this too much mast for this tower? (BTW - I'm aware the boom length
exceeds the 10' maximum for this tower, but the HBX 48 handled a similar
tribander for 30 years, with occasional severe ice-loading, without any
problems.)
Thanks and 73,
Randy, ND0C
________________________________
This e-mail and any files transmitted with it are confidential and intended
solely for the use of the individual or entity to whom they are addressed. If
you have received this e-mail in error please notify the system manager:
postmaster@merial.com This e-mail and its attachments have been scanned for the
presence of computer viruses, however it is always advisable to run a virus
check on e-mails and attachments before opening them.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|