Towertalk
[Top] [All Lists]

Re: [TowerTalk] Tower grounding

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Tower grounding
From: John Ammeter <jammeter@cablespeed.com>
Date: Mon, 22 Jul 2013 13:27:31 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
That's connected to the neutral conductor on the pole. That way neutral is constantly the same potential as ground.

John (retired from electric utility) KE7JA
On 7/22/2013 1:23 PM, GALE STEWARD wrote:
Interesting. I've seen utility companies in my area install new wood poles that 
had a coil of heavy copper wire stapled to the bottom of the pole before it was 
installed in the hole. The wire then ran up the pole a bit so that it was above 
ground level when the pole was installed. Don't know what, or how it was 
connected after that.

73, Stew K3ND




________________________________
  From: David Gilbert <xdavid@cis-broadband.com>
To: towertalk@contesting.com
Sent: Friday, July 19, 2013 12:41 AM
Subject: Re: [TowerTalk] Tower grounding

Yup.

Although I can't find it anymore, I swear I saw a diagram in a code book
that called for the 20 feet of copper wire to have a few wraps around
the rebar in the trench before the pour.  Probably that was just to make
sure that the wire didn't get displaced (pushed to the bottom of the
trench) during the pour, but just in case I added some bronze pipe
clamps along the run to affix the wire to the rebar.

73,
Dave   AB7E



On 7/18/2013 8:58 PM, Jim Lux wrote:
On 7/18/13 12:43 PM, David Gilbert wrote:
I didn't say it wasn't possible to do so.  I said that the majority of
residential Ufer grounds in the footing bring the ground wire up to the
breaker panel from outside the footing.
That's the way virtually all the ones here in Southern California are
done, and it's done with a wire laid in the trench with the rebar
before the pour.  I'm going to guess that they don't do the clamp to
rebar is because it takes more stuff to carry on the truck and
probably takes longer AND it requires two different trades to work
together.

If the rebar guys do their work, and then later the electrical guy
comes by and lays the wire in along side, it's just easier.  They have
a big old spool of the bare wire on the truck,

The copper wire comes up through the concrete next to the conduits for
the underground utilities and winds up inside the garage wall, most
likely.
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>