Towertalk
[Top] [All Lists]

Re: [TowerTalk] Boom Supports

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Boom Supports
From: K8RI <K8RI-on-TowerTalk@tm.net>
Date: Wed, 17 Jul 2013 12:55:28 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
On 7/17/2013 11:27 AM, John Lemay wrote:
Chuck

Your proposal is perfectly sound. A number of commercial manufacturers use
this approach. You want to keep the weight to a minimum at the top of the
mast, so use aluminium, not steel.

The great advantage of putting the support "pylon" on the mounting plate is
that you can pre-tension the support ropes before installation, and get the
boom nice and straight. Note that some ropes will stretch more than others
over time so you might want to test it at ground levels for a day or two.

John G4ZTR
<snip>

The old 7L C3i 6-meter Yagi with near a 30' boom uses a tube like this. Tube, or angle Mounted to the mounting plat extending up in this case about 3 or 4 feet and use 1/2" or 5/8" tube for the truss. I replaced the truss with the small Phillystran. As John said, you can tension it before installation.


73

Roger (K8RI)


Thanks in advance!  Always enjoy the wealth of knowledge on this reflector!!

Chuck  KØTVD
www.dxham.net
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk



_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>