On 7/11/2013 12:41 PM, Jim Thomson wrote:
Any harm in pressure washing galvanized tower’s, or steel bases, masts etc ?
I have bird crap and stuff on some portions of mine. Mine is just a small
electric
one... but its capable of ripping the paint off of wooden steps etc, if too
close
or wrong attachment wand used.
If the pressure washer removes any galvanizing, it was already loose and
likely rusting. A good thing about pressure washing a tower, You'll
likely find any hidden rust. I can cut 2 X 4s in two with mine although
the edges are a tad ragged. Not exactly what you'd want for furniture
building<:-))
73
Roger (K8RI)
It would save a lot of time, but I don’t want to damage the galvanized
surface etc.
The idea was to use just enough pressure to clean it without damaging things.
I suppose I could use a soft nylon brush and soap and water too...then rinse.
later... Jim VE7RF
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|