TT:
I bought my trailer hitch connectors for my TailTwister in 2001 from
The Wireman. Worked ever since with no troubles.
73 de
Gene Smar AD3F
----- Original Message -----
From: "Chuck Sudds" <chuck@dxham.net>
To: "Richard Thorne" <rthorne@rthorne.net>
Cc: <towertalk@contesting.com>
Sent: Saturday, July 06, 2013 1:15 PM
Subject: Re: [TowerTalk] static
Recently replace my T2X with an Alpha Spid and put utility trailer
connectors on each end of the cables. When I hooked it all up, no
rotation! Checked and rechecked everything and come to find out, the
utility trailers were BOTH bad! They were a Chinese brand sold by NAPA.
Wired everything up without the connectors and it all worked as it was
supposed to! If you do decide to go this route, be sure to check and
recheck those connectors BEFORE installing them. It's a lot easier to
troubleshoot this type of a problem on the ground rather than 96 feet up
on a tower! Good luck!
73,
Chuck KØTVD
WWW.DXHAM.NET
While that sounds like a good idea, I'd like to suggest either a
multi-pin Cinch-Jones connector or a connector for a utility trailer. The
Pwr-Poles will be hard to keep "straight" as far as 1-1, 2-2, etc. With
the others, it's one plug-up. they are polorized, and you're done.
K9WN Jake
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|