Towertalk
[Top] [All Lists]

Re: [TowerTalk] Vertical Radials

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Vertical Radials
From: David Robbins <k1ttt@verizon.net>
Reply-to: k1ttt@arrl.net
Date: Tue, 25 Jun 2013 08:47:44 -0500 (CDT)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
The more connected the better... but beware, this is a religious argument with 
some so you will hear that the absolutely must be complete separate and you 
must put chokes at the feedpoints, etc... ignore them and connect them 
together, share wires, use welded fence wire, etc... the only thing you want to 
watch out for is crossing wires that aren't well connected which could cause 
rectification. 


Jun 25, 2013 09:25:23 AM, jms_k1sd@verizon.net wrote:

I'm going to be phasing a pair of verticals (HF2V) on a small lot. 



Should each vertical's set of radials be isolated from each other or would
it be OK to allow them to overlap. Or, would it even be more advantageous
to connect both sets of radials together electrically/physically? 



73 James K1SD

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>