To: | GALE STEWARD <k3nd@yahoo.com>, towertalk reflector <towertalk@contesting.com> |
---|---|
Subject: | Re: [TowerTalk] Stainless U-bolt Source (3.5 inch) |
From: | Jack <k4wsb@arrl.net> |
Date: | Mon, 24 Jun 2013 09:58:43 -0400 |
List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
DX Engineering ? Ace hardware ? At 09:36 AM 6/24/2013, GALE STEWARD wrote: I presently doing a rebuild project and I find that I'm in need of some U-bolts (stainless) to fit 3 inch pipe (3.5 inch inside the U).I found a few places but they sold in quantity. I only really need two but would buy a few more to put in stock if necessary.I know that this is a bit of an odd size, at least for antenna hardware. 73, Stew K3ND Jack Hartley K4WSB / VP2MSB #1 DXCC Honor Roll QCWA OOTC "Celebrating over 1/2 century in Ham Radio" _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TowerTalk] Stainless U-bolt Source (3.5 inch), Doug Scribner |
---|---|
Next by Date: | Re: [TowerTalk] Stainless U-bolt Source (3.5 inch), Grant Saviers |
Previous by Thread: | Re: [TowerTalk] Stainless U-bolt Source (3.5 inch), Tom H Childers |
Next by Thread: | Re: [TowerTalk] Stainless U-bolt Source (3.5 inch), Grant Saviers |
Indexes: | [Date] [Thread] [Top] [All Lists] |