Dan,
I think you would be happy with guying the tower at approximately 225
degrees, 345 degrees and 105 degrees and having the rotator sit off the leg
that is in the 105 degree direction. Assuming you have enough room between
the boom to mast plate and the nearest element you should be able to cover
what you want and maybe even ZL. I believe you need at least the distance
from the center of the vertical mast to the outside point of the farthest
leg of the tower. Depending on how you mount the rotator 24 inches should
be good for 45G, for example.
73...Stan, K5GO
On Wed, May 29, 2013 at 11:20 AM, Dan Atchison <N3ND@aol.com> wrote:
> Stupid question, but I want to make sure I'm visualizing this correctly.
>
> I'm planning a new tower installation that will include a swinging gate
> antenna mount somewhere down the tower. Antenna rotation desired is on
> this mount is CW, 270 through 180 degrees . Based on experience, what's
> the best way to configure the tower's guy location/direction?
>
> 73,
> Dan
>
> ______________________________**_________________
>
>
>
> ______________________________**_________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/**mailman/listinfo/towertalk<http://lists.contesting.com/mailman/listinfo/towertalk>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|